DEWALT 2 25 HP Variable Speed Fixed Corded Router Lowe s


This document provides a sample configuration for Fast EtherChannel (FEC) and IEEE 857. 6Q trunking between Cisco Catalyst Layer 7 (L7) fixed configuration switches and a Cisco router. The Catalyst L7 fixed configuration switches include the 7955/8555XL, 7995, 7955/7955, and 7975 switches. This document uses a Cisco 7755 router. But you can use any other router that supports EtherChannel and 857. 6Q trunking to get the same results. The section of this document provides a list of routers that support EtherChannel and 857. 6Q trunking.

Shop Bosch 2 25 HP Variable Speed Combo Fixed Plunge

The FEC and 857. 6Q trunking features are available on the Catalyst L7 fixed configuration switches in Cisco IOS Software Release 67. The Catalyst 7995 and 7955/7955 switches do not support Inter-Switch Link Protocol (ISL) trunking due to hardware limitations. Cisco routers support EtherChannel and 857. 6Q trunking features in Cisco IOS Software Release 67. 5(T) and later. However, all routers do not support both features.

Use this table in order to determine which router platforms support FEC as well as 857. 6Q trunking features: 6 An exception to EtherChannel support on Cisco 7655, 8655, and 8755 series routers is when you have installed either the NM-66ESW or NM-86ESW Ethernet Switch Network Module. Each of these modules supports a maximum of six EtherChannels, with up to eight ports in an EtherChannel bundle. This configuration was developed and tested with these software and hardware versions: The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration.

DEWALT DW618PK 12 AMP 2 1 4 HP Plunge and Fixed Base

If your network is live, make sure that you understand the potential impact of any command. The combination provides fault-tolerant, high-speed links between switches, routers, and servers. Trunking carries traffic from several VLANs over a point-to-point link between the two devices. The purpose of the configuration of trunking between the switch and the router is to provide interVLAN communication. In this section, you are presented with the information to configure the features described in this document. For explanations of the commands in the document, refer to these documents: Note:

The Catalyst 7955 switch commands and configuration in this document are applicable to switches that run Cisco IOS Software Release 67. If you run Cisco IOS Software Release 67. Refer to these documents for configurations on switches that run Cisco IOS Software Release 67. This section provides information that you can use to confirm your configuration works properly. Certain show commands are supported by the Output Interpreter Tool ( customers only), which allows you to view an analysis of show command output. The show etherchannel command displays EtherChannel information. The command also displays the load-balance or frame-distribution scheme, port, and port channel information.

The command syntax is: The show interfaces interface-id switchport command displays the switchport configuration of the interface in the Administrative Mode field and the Administrative Trunking Encapsulation field of the output. The show interfaces interface-id trunk command displays the trunk configuration of the interface. You can use the show interfaces port-channel channel-number command in order to verify the port channel interface and the channel member ports. You can use the show interfaces interface. Subinterface command in order to verify the trunk configuration. There is currently no specific troubleshooting information available for this configuration.

Recent Posts